- Duratec 2.0l on Webers Coil Pack Lead Configuration
- Clutch flywheel issues
- Clutch flywheel issues
- Info Request: Fiesta ST GpN exhaust manifold
- Hydraulic clutch bleed hoses
- Piston options if rebore is required?
- Duratec RWD ranger sump on MK1 escort duretec
- Duratec steel oil sump flange
- Which Duratec equipped cars came with singlemass flywheels? Where to buy secondhand?
- Replacing a plastic cam cover with the alloy one?
- Oil take of plate
- Cop
- Help Wanted: Ls-Lt vs Lv engine
- Mazda 2.0 Duratec
- Duratec 2.5 VVT removed, What cams?
- 2.5 Litre Duratec Cylinder Head on a 2.0 litre block
- Where to buy new 2.0 Duratec?
- DTA 40 Ecu Ignition only. Has anyone used one of these on a 2.0l Duratec.?
- Mazda 5 speed slave cylinder
- Cam recommendation for a road race motor.
- Duratec conrods
- 2, 2.3 or 2.5 - naturally aspirated or turbocharged?
- Jenvey Heritage Throttle Bodies
- Here goes
- ST150 vs Mondeo flywheel diameter - are they the same?
- Info Request: MX5 Gearbox propshaft Q
- Duratec Exhaust manifold
- Advise please
- When did Ford go to VVT on Duratec?
- RX8 gearbox to Duratec 2.0?
- Raceline wetsump in FWD application
- Cosworth cam friction washers?
- Building 250-270bhp duratec
- 1s7g (low port) head flow?
- Duratec What do I do with this?
- Pistons and Rods for Duratec 2.4 l
- Duratec turbo experience and advise
- Duratec build options
- Engine choice
- clubman spec duratec
- EGR delete
- Camshaft Sensor Position Gap Between Sensor and Lobe
- Turbo oil feed and drain pipe advice
- Help Wanted: Duratec hydraulic clutch issues
- 2.0 and 2.3 dura pistons
- Duratec oil filter plate
- 2.4L Duratec Build
- Duratec won’t start help!!!!
- 50mm throttle bodies on 240 - 250bhp dura
- Duratec camshaft lift profile