Atlas bearings appear too deep
The bearings in my half shafts appear to be 2mm deeper than the grooves in my atlas, so the drive shaft flange doesnt quite sit flush with the axle flange, is this normal? https://uploads.tapatalk-cdn.com/201...5a6f6d5603.jpg
Sent from my SM-A520F using Tapatalk
Atlas bearings appear too deep
You should have a spacer to make up for the drum backplate 👍
If using bolt on brackets for callipers I think they do the job.
Sent from my iPhone using Tapatalk
Atlas bearings appear too deep
Ahhhh that makes sense, ta mate
Sent from my SM-A520F using Tapatalk
Re: Atlas bearings appear too deep
has the axle stub been cut and rewelded back on
Atlas bearings appear too deep
As per wildo Ford allowed the back plate to fill that gap.
Please don't be tempted to just tighten in the 4 bolts 😋
Small spacer will solve it!
Sent from my CLT-L09 using Tapatalk
Re: Atlas bearings appear too deep
Re: Atlas bearings appear too deep
i think so yes, i believe it was shortened to baby atlas width
Re: Atlas bearings appear too deep
Re: Atlas bearings appear too deep
Quote:
Originally Posted by
5tox i think so yes, i believe it was shortened to baby atlas width
One last thing worth checking that you are not bottoming out on the half shaft in the diff (if you have one fitted) if not back to the spacers which is the most likeliest.
Re: Atlas bearings appear too deep
Thanks for the head up, i have no diff at all yet but will make sure the shaft dont bottom out