Hi, are the inner track control arm to crossmember bolts different on a Mk1 & Mk2 ? On after market arms there seems to be a lot of slack in the bush.
Hi, are the inner track control arm to crossmember bolts different on a Mk1 & Mk2 ? On after market arms there seems to be a lot of slack in the bush.
Does anyone know the thread of the studded part coming out of an rs2000 engine mount ?
Hexham and District Motorclub
Should be M10
1974 MK1 Escort - Work in Progress
Thank you
Hexham and District Motorclub
Already posted this in discussion before noticing this part. Cross flow inlet bolts can anyone tell me the thread where you bolt the carb on. I know it's not m8
It will be UNC I guess, whichever one a 1/2" spanner fits onto.
Does anyone know english axle half shaft retaining bolts? X4 on each side? I think they are unf not 100%
also front leaf spring bolt and rear leaf spring shackle nut?
Nudger, it's not a bolt, it's the blanking plug for the water jackets. Not sure what size it is but it is a brass hex headed plug and it's tapered so it is probably NPT.
Cheers Tony. Does anyone know what size it should be?
What size are the anti tramp bolts? That fit through the (front) brackets not axle
Thats listed above i posted it
Inlet manifold bolts are 5/16unc
Ive just been turning some
Hexham and District Motorclub
does anyone know what size of bolt and thread is used to hold a compression strut cone assembly together. this is the part that clamps through the TCA and is socket head. It seems to be a very fine thread to anything else i have lying around.
thanks
Ok so did some measuring and got 9.34mm or 0.367 inch which from googling i think is 3/8 so i reckon 3/8 unf x 1 inch does this sound correct not really an expert on imperials👍
posty dropped some off today. 3/8 unf defo
Can anyone help with nut size for the 4 servo mounting studs? (RS 7" servo, the nuts from a std servo are too small)
Thanks in advance .
Anyone now the front bumper iron bolt thread size, so I can purchase some square nuts to replace my worn ones and weld in?
Does anyone know the thread size of the bonnet catch that screws into the inner front of the bonnet?
Anyone know the thread of the screws that hold front indicator lense on
For a mk2 escort
Hexham and District Motorclub
I'd hazard a guess at M5 x 0.8 but they might be M4 x 0.7
I'm sure they'd be metric though as the Mk2 is..
No not m5 tried that
Thinking they might be m4 but a bolt I had that was the same size and thread took a 1/4 socket ?
Hexham and District Motorclub
1/4 would be either 6 or 7 mm wouldn't it.
These screws are M4x12 (sometimes also listed as M4x14).
thanks miniliteman
Hexham and District Motorclub
anyone tell me the thread on this please water outlet on pinto inlet manifold please
MY MK1 ESCORT (Now turbo'd)
Mk1 Escort 1.3 XFlow Turbo - http://bytesandbolts.com/tag/mk1-escort/
anyone know where I can buy a complete nut and bolt
thankyou. kit for a mk.2 rs2000.
Bookmarks