Pit Crew
Ford coil (EDIS module era) leads to suit XE
Hi Folks, stupidly with so much other stuff going on i never actually checked if these would fit my setup, even though they have been sitting in a box for 6 months
im running Megajolt on my XE with the EDIS module and Ford coil pack setup ( the one with the plastic clips to hold the leads onto the coilpack)
however even with the rubber sealing rings shaved off the leads, theyre still marginally too short to reach the plugs, has anyone any recommendation on what to use XE-ford coil? i dont actually have any XE leads, so i dont know if they would fit in the ford coil pack properly ?
many thanks
-
Pit Crew
Re: Ford coil (EDIS module era) leads to suit XE
-
Re: Ford coil (EDIS module era) leads to suit XE
I had a similar problem and got this set. You can make them to your own length. They got plenty length to start with.
They have high EMI resistance and low ohm resitance.
http://www.ignitionproducts.eu/nl/ms...ctor-boug.html
If you wanna go cheap, get ka leads and a coil that uses the push on cables.
But the bit that connects to the spark plug isn't fully straight so a pain to get on spark plug
Last edited by haadee; 24-05-2016 at 17:43.
-
Pit Crew
Re: Ford coil (EDIS module era) leads to suit XE
super thanks! thats not too bad i guess, are they the exact connections for the ford coil? they look like they are, thanks!
-
Re: Ford coil (EDIS module era) leads to suit XE
Yes they are a direct fit to the ford coil, because msd also reproduces them
-
Pit Crew
Re: Ford coil (EDIS module era) leads to suit XE
great thanks just ordered a set !
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks