2.0 Pinto. not running right?
Hi Guys.
So I have a 1978, 2.0 Pinto with single weber 32/36 DGAV
Wasn't running right (Points had burnt out)
I've fitted new. Points, condenser, HT Leads, Dis cap, rotor arm, plugs.
Checked all vacuum pipes are clear.
Will start and run no problem but will only run flat out! / Like choke is on all the time. Will not tick over just cuts out if you tap the throttle.
So fuel is getting through fine. good spark.
Was running fine before points burnt out.
Any ideas what might be wrong?
Thanks Bryan
-
Re: 2.0 Pinto. not running right?
Have you set the ignitiontiming correctly?
Are the HT leads on the right way?
Remove the idle jets and blow them through.
-
Re: 2.0 Pinto. not running right?
Sounds like massively advanced timing.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks