Cosworth YB engine + T5 box

[PF Luke]

2-litre Cosworth YBT, CR Turbos T34 .63 turbo with -31 actuator, 3-bar map sensor, 205 block machined for Cosworth Group A forged pistons, 8.0:1 compression ratio, Cosworth Group A forged pistons with valve pockets, standard Cosworth crank re-ground to take .25 Mahle Motorsport bearings and APL big end bearings, skimmed flywheel, re-conditioned head with new valves, guides and stem seals, re-built dark green injectors, new tappets, new high pressure oil pump, ARP bolt kit, new 2WD water pump, Group A cambelt and tensioner with WRC nut, full Ultimate Sensor kit from Matt Lewis Motorsport, new cam bearings, new Group A coil, new bolts, seals and O-rings, powder coated cam cover, L1 ECU with Bajoo chip rated at 380bhp, Bailey Motorsport dump valve, Bailey Motorsport breather set-up, turbo damper, Magnecore HT leads, silicone boost hoses, braided water feed turbo hose, 2WD exhaust manifold, full Burton Power gasket set and WRC head gasket, G19 Engineering big wing sump with sump baffle.

Plus T5 gearbox.

Also got an AutoSpecialists intercooler/radiator kit for Mk1/Mk2 Escort that I might negotiate into the deal.

£4750.

It's never been used, was built less than 12 months ago by Lee at Devil Developments. If I can figure out how to get photos on here, then I will put some up, but otherwise PM or text me and I'll email them, or message them over. 07748 707910

Cheers

Luke

[PF Luke]

Forgot to mention it needs a dipstick and the bottom pulley isn't fitted at the moment. Pulley will be included in sale though.

[Mkdu]

Hi,
Is it the engine from the "project Asbo" ?

[Mkdu]

the N/A one you had, finally is sitting into my car....