By dazzles9r at 2010-10-08
By dazzles9r at 2010-10-08
So, with the main part of the cage in, it was time to look at the rear suspension
By dazzles9r at 2010-10-08
By dazzles9r at 2010-10-08
Do these look familiar?? They're from the back of the Imprezza! The thought process behind this project is for it to look like it was factory produced! So, if we can use part of the Imprezza, we will
By dazzles9r at 2010-10-08
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
A little bit of template use and drawing took place and then a trial fit. Bonus was we had a rear strut brace as well, so we could use that to make sure the tower tops were the correct distance apart!!
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
Due to the contours of the Imprezza part and the contours of the rear of the Fiesta, we couldn't use the whole tower, so we ended up just using the tops!
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
Then we tied in the rear strut towers to the main cage!
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
By dazzles9r at 2010-10-09
We'll be connecting the 2 strut towers together with a strap bar but will do this after we have finished all our fabrication in the boot area
Bookmarks