2.1 Pinto - fresh rebuild
Fresh rebuild by Wayne Mitchell completion engines, dyno miles only since rebuild, engine spec as follows:-
205 block, Standard crank, steel rods, 93mm forged pistons, HD ACL lead/copper bearings (BE & mains), cometic multilayer steel head gasket, was new stem seals, BV head, HT1 camshaft, HP oil pump, ARP head/BE/flywheel bolts, light steel flywheel (double dowelled), H&H electronic dizzy and coil. Bottom end all lightened and balanced. Brand new set of 48’s+ linkage, red top pump & fuel regulator, AP paddle clutch. New water pump. Has been Dyno setup - 191BHP, 160 ft/lb torque, nice flat torque curve (140 ft/lb @ 3000 rpm). Alloy sump & rocker cover. Looking for £5500 ono
Sent from my iPhone using Tapatalk
-
2.1 Pinto - fresh rebuild
Bump
Sent from my iPhone using Tapatalk
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks