Help needed on group 4 studs

[uknuta]

Can anyone help me out with fitting group 4 studs to alloy hubs. they are all pressed in and good to go, just curious what the torque setting is for the nut on the back side of the hub, and also does the thread get peened over or tack welded to stop nut coming loose?

Any help greatly appriciated.

[marshyboy2002]

Nut on the back side of the hub?

[uknuta]

The nut that holds the group 4 stud into the hub, the one that is on the back of the hub

[mick32]

i normally use locktite on the threads and give the back nut i right good nip up prob about 40 to 50 nm