Back on the tools again!
Pulled all the bits from the boot to gain access to the entire fuel line, so I can replace it, from the pump to the carbs
The fuel line, battery positive and chassis harness all ran through the same opening in the firewall and was sealed off by some expanding foam.
It was easy to find where someone had cut/spliced the rear harness already which made it easy to move into the main cabin.
The boot floor is in need of some mending and there's a good number of patches to be sorted out as well.
The battery positive cable was also spliced, so it will be completely replaced with a heavier gauge piece.
It's all pulled though and just a bit more work in the cabin and moving on to the engine bay.
Bookmarks