Hey all, have I bolted these together correctly? or do you flip the black bit 180 degrees and put on other side of disc? cheers!
Hey all, have I bolted these together correctly? or do you flip the black bit 180 degrees and put on other side of disc? cheers!
Does the Caliper not line up with the disc as they are? I have the same style of 2 piece disc carnt rember how mine are, but the caliper lined up spot on.
Caliper is 2mm off, lines up with a washer under it, but steering track rod ends are almost touching the disc
Disc is on the wrong way round then
Hard to tell from the pic but the caliper looks in the wrong position too, looks like the mounting bracket is on upside down
disc is right as it has a rh (right hand) and an arrow for rotation
looking at that id gets that maybe the mounts just haven't been made quite right, mine done have mounts and bolt straight on to the hub / strut assembly
I think the main issue is the disk near the Track rod end. I had this and had to space the bearings a little , although still close. Callipers are easy to shim and adjust. Mine was a semi odd fitment but this I assume should be a developed kit.
From memory mine is very close to the trackrod end, I’ll take a picture tomorrow
Bookmarks