When honing the cylinders should you be able to physically feel the scratches with your finger nail?
I literally run the hone up and down for just a few seconds with plenty of oil but the cross hatching scratches i can feel with my fingernail which doesnt seem right?
Apparently the duratec uses cast iron liners which i assume is softer than steel.
I have also caught the deck of the block scratching the surface slightly around what i assume is an oil return from the head and a head bolt hole.
Should i get the deck lightly skimmed or leave it and hope for the best?
Sent from my SM-A520F using Tapatalk
Bookmarks