MLS Head gasket to bore diameter.

[fingersnfumbs]

A quick question.

I have a Pinto block bored to 92mm.

I already have a MLS head gasket of the correct thickness but its 93.5mm. Compression works out within spec even with this gasket but what about the bore.
Would it be OK to fit a 93.5mm to a 92mm block?

[Graham]

A quick question.

I have a Pinto block bored to 92mm.

I already have a MLS head gasket of the correct thickness but its 93.5mm. Compression works out within spec even with this gasket but what about the bore.
Would it be OK to fit a 93.5mm to a 92mm block?

it will be absolutely fine

[fingersnfumbs]

Thanks Graham.

Great you tube channel by the way.

I subscribed last week.