St170 dtas60

[haadee]

Is there anyone out there that has got full vvt working with a DTAS60 ecu?
I have the engine running, but it does not read the cam position.
When using the oscilloscope function I can see the ECU gets 5 pulses from the sensor in 2 crankshaft rotations.
I have selected flywheel mode 13 - ST170 36-1 / 5 tooth cam wheel.

Does anyone have an idea what could cause the DTA to not process the pulses to a cam position value?
(cam sensor noise filter is deselected in sequential injection menu)
The ECU is on firmware 41.00

[katana]

Sorry - no idea but have you tried the DTA Forum - http://www.dtaforum.com/index.php DTA's owner often is on there answering questions / assisting with diagnosis's.
I can't even imagine how an ECU uses 5 pulses in 720 degrees of crankshaft rotation ? ( 720/5 = 144 deg?)

[haadee]

The trigger pattern/wheel on the inlet camshaft is not a symmetrical pattern.
It should be defined in the chosen settings that I mentioned that have been selected.

Will give that forum a try also.

[haadee]

The trigger pattern/wheel on the inlet camshaft is not a symmetrical pattern.
It should be defined in the chosen settings that I mentioned that have been selected.

Will give that forum a try also.

http://www.dtaforum.com/viewtopic.php?f=5&t=2135