If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Trial fitted the fan onto the rad, but it was fouling on the bracket for the oil cooler
Before
After, bracket chopped and moved, duct tape was only temporarily, I can’t do alloy welding, so it was dropped off to a buddy to do it
Fitment was tight afterwards but it fits
Also decided while I was at it, to drill and tap some flat steel, and tack them in place to make rad fitment easier, especially with the oil cooler in the way
Last edited by Chris11090; 14-02-2021, 21:20.
Reason: Wrong photo
Next up was a gearbox mount, I had originally made one to suit a type 9 dog box, but have since made the move to a tractive 6 speed, so set about modifying mine to suit.
Not the best of photos but happy with my welding
One goes across the floor and bolts up both sides of the tunnel, and has an rs engine mount rubber sitting on it, that goes onto another plate that bolts onto the back of the box.
Also I can use the original mount to attach an extension to the sump guard if I want to run a guard back under the gearbox
Next up was a mount for a switch panel, which would have a side piece for the pull cord for the fire extinguisher and also an extra button at the top for the battery cut off.
8 buttons, which will be programmed to suit, and operate via can bus or some magic like that.
Comment