Bodger
-
Pinto stroker torque wrench settings...
I’m in a field at silverstone so can’t access any torque settings until next week.
But use the torque setting for diesel rods. ARP usually list torque settings for stuff in there online catalogs, its usually also on a bit of paper in the packet under the lube
Sent from my iPhone using Tapatalk
-
Bodger
-
Re: Pinto stroker torque wrench settings...
oil demands wont really change so stick with the same 20w50 oil as before.
with the big end torques, yb, diesel and pinto all have different bolt designs, so there will be differences there. i have just re read your post, your using YB rod bolts so use the YB torque setting.
-
Racer
Re: Pinto stroker torque wrench settings...
And if its a totally fresh engine - pistons, rings, cam, bearings etc. - use the cheapest mineral 20w-50 you can find, start it and set idle at 2-2,500rpm and run for min. 20 minutes then stop and let it cool off. Check head bolt torque and tappet clearances. Next start adjust idle, drive for 30 - 50 miles moderate speeds, stop and drop oil and filter. New filter and oil 20w-50 mineral or semi synth - enjoy
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks