Categories
Collapse
article_tags
Collapse
Latest Articles
Collapse
-
by madmaxpttI am building a 2,3 pinto with twin dcoe 45s.
I think for my setup the HT1e with Gp1 BvH is better
what is your advice???-
Channel: Welcome to Turbosport
27-03-2024, 11:52 -
-
by ZakspakBreak pedal box back on the bench for fitting the break light switch and setting the pedals up.
I stripped the switch and cleaned it, then cut down the threaded section and the switch plunger.
The pedals have been cleaned and the little surface rust removed and freshen up with a coat of gloss black
The white line is a datum for the neutral position
Output pipes fitted using copper sealing washers before fitting
...-
Channel: Welcome to Turbosport
09-08-2023, 16:39 -
-
by ante1970Ok boy. Thank's at all. Today, with help of my father in law have finished " modification with hammer" of oil pickup and make little space for conrod bolt ! Post some pics of work ! Another time thank 's HonkyWhiteTrash and Daniele....
-
Channel: Welcome to Turbosport
08-05-2023, 19:15 -
-
by MO1Wanted
Good usable SIERRA Cosworth 16V head complete or minus valves. But must have cam caps. Cheers-
Channel: Welcome to Turbosport
27-04-2020, 20:23 -
-
by ZakspakOn to the centre sections. New metal on to new metal. Nice ! I welded extra plates in where the jacking point is to increase its strength, hopefully to stop it becoming dented when on stands or jacking. I over laid the new sections against the originals to check alignment, and marked them for drilling the plug weld holes. Again insides where painted with the gloss black. I marked where the originals where and removed them. Due to the replacement floor it was just a matter of un-bolting th...
-
Channel: Welcome to Turbosport
21-02-2019, 16:26 -
-
by markbRyou should be abel to reduce the size by editing them in paint or similar.. to post them upload them using the link at the top of the page and copy the test it gives you into a post ...
-
Channel: Welcome to Turbosport
29-05-2017, 16:30 -