If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Do you have any pics of your seat mounts, I'm trying to work out a better way to mount my one lower but the sierra floor pan is not exactly flat, especially by the tunnel
Sierra cosworth turbo race car QMN saloon car championship RETRO Motorsport
This is a picture of the seat mount.We have made a cut at the tunnel as you can see,and it is a lot lower than standart.Here we have to race with FIA regulations seat mounts,but these are much more stronger !!!!
Thaks Nick, that looks very nice. I had a look at some other RS500s yesterday and everyone has mounted their seats differently but none of them seem much lower than mine. I might just hold off until I buy a fancy new seat at the end of the year and make something like yours except they will probably run along the floor instead of across it
Hows the progress on the car now Nick, bet you can't wait to try it
Sierra cosworth turbo race car QMN saloon car championship RETRO Motorsport
Stunning work as usual, the attention to detail, especially on the engine, is amazing
I see you have the same sierra engine mount brackets as me, do you use vibra technics alloy mounts, mine seem pretty good Some people just use solid mounts instead but I'm not sure yet if I like that idea, at least mine have a bit of rubber in them to take out the vibrations
Sierra cosworth turbo race car QMN saloon car championship RETRO Motorsport
Comment